Contact Us

Contact: Jinchun Du
Mob: +8613506161985
Contact: Tony Gao
Mob: +8613812107230
Tel: +86-510-86151034
Fax: +86-510-86012118

E-mail: 13812107230@163.com
Address: Yun Gu Road No.3, Yunting Town,Jiangyin City,Jiangsu Province,China

Home > Knowledge > Content
High Speed Centrifugal Atomizing Dryer Should Meet The Conditions
Feb 28, 2018

High speed centrifugal atomizing dryer is the air through the filter and heating, into the top of the dryer air distributor, while the hot air spirally into the drying chamber evenly; and feed liquid by the tower top of the high-speed centrifugal atomizer spray Very fine mist droplets, and hot air cocurrent contact in a very short period of time can be dried into finished products.

 

Immediately afterwards, the finished product is continuously discharged from the bottom of the high-speed centrifugal spray dryer and the cyclone, and the exhaust gas is exhausted by the fan. When the wet material into the high-speed rotating disk, the role of centrifugal force to form film-like droplets, and at an ever-increasing speed, moving to the edge of the turntable and spray into filamentous droplets.

 

In the use of this dryer, the requirements of high-speed centrifugal atomizing dryer must meet the relevant requirements, for example, in order to facilitate monitoring, check the drying equipment operation, the need for high-speed centrifugal spray dryer to set the hole, lamp hole and temperature, Pressure indicator recorder and other monitoring devices.

 

At the same time, but also to strengthen the role of high-speed centrifugal spray dryer air filtration, reduce impurity levels, improve product purity. The dust recovery device used also has a higher recovery rate, at the same time easy to clean, reliable operation and reduce unnecessary failure rate.

 

As a drying equipment, high-speed centrifugal atomizing dryer should have better insulation and airtight, high thermal efficiency, good economic effect; Do not forget to also develop measures to prevent hot air swirl or countercurrent to reduce coke powder phenomenon.

 

In order to improve the solubility and preservability of the products, the dried products in the high-speed centrifugal atomizing dryer should be rapidly cooled and packaged. After the products are recovered by adding water, the original color and fragrance should be maintained. The entire equipment, where the contact with the product parts, should be made of stainless steel, to extend its service life.

 

http://www.nf-drying.com/


Previous: Pressure Spray Granulation Drying Machine Spray, Granulation, Drying process

Next: Advantages of Air Stream Spray Dryer