Contact Us

Contact: Jinchun Du
Mob: +8613506161985
Contact: Tony Gao
Mob: +8613812107230
Tel: +86-510-86151034
Fax: +86-510-86012118

E-mail: 13812107230@163.com
Address: Yun Gu Road No.3, Yunting Town,Jiangyin City,Jiangsu Province,China

Home > Knowledge > Content
High Speed Centrifugal Atomizing Dryer is how to achieve energy-saving purposes
Jun 06, 2018

No matter what the drying equipment, how to make the drying equipment to achieve energy saving and the best drying effect is a problem that many customers have been concerned about. Then, we will bring you three effective ways of High Speed Centrifugal Atomizing Dryer energy saving, which will help reduce the cost of users.

 

In order to make the High Speed Centrifugal Atomizing Dryer more energy-efficient, the first thing that can be done is to properly increase the temperature of the hot air into the tower. In the condition that the tower temperature is constant, the higher the inlet temperature of the hot air, the higher the total heat brought in. The more heat the unit mass of hot air will transfer to the mud droplets, the more moisture the unit hot air will evaporate. .

 

When the High Speed Centrifugal Atomizing Dryer has a constant production capacity, the amount of hot air needed is reduced, which reduces the heat consumption of the high-speed centrifugal spray drying mechanism powder, thereby improving the utilization rate and thermal efficiency of the hot air. However, the temperature of hot air entering the tower must not be too high.

 

Secondly, lowering the tower temperature of hot air is also one of the ways to make the High Speed Centrifugal Atomizing Dryer more energy-efficient. When the temperature of hot air entering the tower is certain, the lower the temperature of the hot air exiting the tower, the greater the difference in temperature between the tower and the tower. The greater the heat energy that the hot air passes to the slurry for drying, the higher the utilization rate of hot air. But in the same way, the exhaust temperature of a High Speed Centrifugal Atomizing Dryer cannot be too low.

 

In addition, the recycling of hot air out of the tower of the High Speed Centrifugal Atomizing Dryer can also greatly contribute to saving energy consumption of the equipment. If the tower's hot air is directly discharged into the atmosphere, this part of the heat loss will be considerable, so this part of the waste heat should be fully utilized.

 

For the moment, we can use the hot air from the High Speed Centrifugal Atomizing Dryer to the preheating drying process. Of course, in addition to the direct recycling of hot air from the tower, it is also possible to use heat exchangers to store or exchange this waste heat before use.

http://www.nf-drying.com/


Previous: Insulation system and heat source device for Pressure Spray Granulation Drying Machine

Next: Air Stream Spray Dryer Operation and Maintenance Procedures and Precautions